Evolution E.T.S. II™

With the E.T.S. II you can easily assign different functions to the selector lever’s SEMI and AUTO positions. With its advanced programming functions you’ll be able to customize the behaviour of your replica and make it do exactly what you want by using just the selector lever and the trigger, without any limitation or need to use external units to program the functions or to buy additional software to unlock the most advanced features. To program the functions it is not necessary to disconnect the battery, you will be able to change the functions easily and in seconds also during games

Which are the functions?

CONFIGURABLE FIRE SELECTOR

Assign independently to the SEMI and AUTO positions one or more functions for 10 different combinations:

  • SAFE – SEMI – AUTO
  • SAFE – BINARY TRIGGER – AUTO
  • SAFE – 3 BURST – AUTO
  • SAFE – SEMI – 3 BURST
  • SAFE – SEMI – 5 BURST
  • SAFE – SEMI – 3 BURST/AUTO
  • SAFE – SEMI – 5 BURST/AUTO
  • ACTIVE BRAKE OFF/ON
  • SNIPER DELAY ON/OFF
  • RESET

BINARY TRIGGER

The gun fires one BB when the trigger is pulled and one BB when the trigger is released, enabling the user to shoot in semi auto at double speed

3 BURST SEMI

The gun fires a burst of 3 BB’s when the selector is on SEMI

3 BURST AUTO

The gun fires a burst of 3 BB’s when the selector is on AUTO

5 BURST AUTO

The gun fires a burst of 5 BB’s when the selector is on AUTO

RAMPING FULL AUTO

ON / OFF
When the selector is on AUTO the gun fires a burst of 3 or 5 BB’s, keeping the trigger pulled after the burst gun switches to full-auto and continues firing until the trigger is released. Requires functions 4 or 5 active

ACTIVE BRAKE

OFF / ON
The electromagnetic brake: The active brake avoids double shots and piston bounce when using high voltage batteries.
Deactivate it for Speedsoft or if grip becomes hot

SNIPER DELAY

ON / OFF
Simulation of a bolt action operation with a 1 second pause between shots. During pause the optical signal is on. Deactivate it before activating functions 1, 2, 3

LOW VOLTAGE PROTECTION

The battery is constantly monitored and the power is cut-off if the Voltage falls below the security level to avoid over discharge that may damage the electronic unit

VOLTAGE DETECTION

The gun automatically recognizes the batteries Voltage

CYCLE CONTROL

The unit stops the piston only after a shooting cycle is completed and always in the same position increasing shooting consistency

MOTOR DIAGNOSTIC

The unit constantly check the motor parameters.
In case the motor parameters go out of range, the unit enters in Protection Mode to avoid damages, an optical signal and a vibration are activated in order to alert the user (3 optical signals and 3 vibrations)

BECOME A DISTRIBUTOR

Business inquiries: info@evolutioninternational.it